2010 Toyota Sienna Service Manual Site Www.siennachat.com

Order Toyota Sienna Repair Manual - Vehicle online today. Free Same Day Store Pickup. Check out free battery charging and engine diagnostic testing while you are in store. Get the best deals on Toyota Sienna Car Manuals & Literature when you shop the largest online selection at eBay.com. Free shipping on many items. 2002 Toyota Sienna Service Repair Manual Set. 1998 Toyota Sienna Van 28-page Original Car Dealer Sales Brochure Catalog. Other materials: Perform zero point calibration of yaw rate and deceleration sensor (when using sst check wire) NOTICE: While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it in a stationary condition.

Toyota Sienna Service Manual / Exterior / Front bumper / Disassembly

1. REMOVE FRONT BUMPER ENERGY ABSORBER

2. REMOVE FRONT BUMPER REINFORCEMENT SUBASSEMBLY

  1. Remove the 6 bolts and the front bumper reinforcement sub-assembly.

3. REMOVE FRONT BUMPER SIDE SUPPORT LH

  1. Remove the screw.
  2. Disengage the 2 clips and remove the front bumper side support LH.

4. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT: Perform the same procedure as for the LH side.

5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (See page PM-19)

6. REMOVE NO. 1 ULTRASONIC SENSOR (LH side) (w/ Clearance Sonar System) (See page PM-19)

7. REMOVE NO. 1 ULTRASONIC SENSOR (RH side) (w/ Clearance Sonar System)

HINT: Perform the same procedure as for the LH side.

8. REMOVE RADIATOR GRILLE

  1. Remove the 2 bolts and the 2 screws.
  2. Disengage the 4 claws and remove the radiator grille from the front bumper cover.

9. REMOVE UPPER RADIATOR GRILLE

  1. Disengage the 10 claws and remove the upper radiator grille from the radiator grille.

10. REMOVE FRONT BUMPER EMBLEM

  1. Disengage the 3 claws and remove the front bumper emblem from the upper radiator grille.

11. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)

  1. Disengage the 2 pins and remove the front bumper hole cover LH from the front bumper cover.

12. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT: Perform the same procedure as for the LH side.

13. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light) (See page LI-82)

14. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT: Perform the same procedure as for the LH side.

15. REMOVE LOWER RADIATOR GRILLE

  1. Disengage the 16 claws and remove the lower radiator grille from the front bumper cover.
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT BUMPER ASSEMBLY Remove the 4 screws and separate the fender liner from the front bumper assembly. Remove the 8 ...
Reassembly
1. INSTALL LOWER RADIATOR GRILLE Engage the 16 claws to install the lower radiator grille to the front bumper cover. 2. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light) Engage ...
Site
Other materials:

Low Battery Positive Voltage
DTC C1241/41 Low Battery Positive Voltage DESCRIPTION If there is a problem with the brake actuator assembly (skid control ECU) power supply circuit, the skid control ECU outputs the DTC and prohibits the ABS operation with the fail safe function. If the voltage supplied to the IG1 termina ...

Reassembly
1. INSTALL FRONT DISC (a) Aligning the matchmarks, install the front disc. HINT: Select the installation position where the disc has the minimum runout. 2. INSPECT DISC RUNOUT (a) Temporarily fasten the disc with the hub nuts. Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) (b) Using a ...

2011 Toyota Sienna Xle Manual

Passenger Airbag ON/OFF Indicator Circuit Malfunction
DTC B1152/28 Passenger Airbag ON/OFF Indicator Circuit Malfunction DESCRIPTION The passenger airbag ON/OFF indicator circuit consists of the center airbag sensor assembly and passenger airbag ON/OFF indicator. This circuit indicates the operation condition of the front passenger airbag, t ...

We are proud to announce a significant enhancement to our Hybrid Battery Warranty. Starting with the 2020 model year, every Toyota hybrid battery warranty is being increased from 8 years or 100,000 miles, to 10 years from date of first use, or 150,000 miles whichever comes first. This enhancement serves as an indication of our confidence in the quality, dependability, and reliability of our products.

2008 Toyota Sienna Manual Pdf

On top of our basic coverage, we offer:

Toyota 2014 Sienna Manual Download

Hybrid-Related Component Coverage1 Hybrid-related components, including the HV battery, battery control module, hybrid control module and inverter with converter, are covered for 8 years/100,000 miles. The HV battery may have longer coverage under emissions warranty. Refer to applicable Warranty & Maintenance Guide for details.

Powertrain Coverage1 60 months/60,000 miles (engine, transmission/transaxle, front-wheel-drive system, rear-wheel drive, seatbelts and airbags).

Rust-Through Coverage1 60 months/unlimited miles (corrosion perforation of sheet metal).

Emissions Coverage1 Coverages vary under Federal and California regulations. Refer to applicable Warranty & Maintenance Guide for details.
For Toyota hybrid vehicles beginning with model year 2020, the hybrid (HV) battery is covered for 10 years from original date of first use or 150,000 miles, whichever comes first. Coverage is subject to the terms and conditions of your New Vehicle Limited Warranty. See Owner's Warranty and Maintenance Guide for details.

Read More